7
Sheet No.: D3-A04101EN
GP1A52LRJ00F
?SPAN class="pst GP1A52LRJ00F_2584176_4">Design Considerations
?/DIV>
Recommended operating conditions
Parameter
Symbol MIN.
TYP.
MAX.
Unit
Output current
I
O
16
mA
Forward current
I
F
10
20
mA
Operating terperature
T
opr
0
70
贑
?/DIV>
Notes about static electricity
Transisiter of detector side in bipolar con guration may be damaged by static electricity due to its minute
design.
When handing these devices, general countermeasure against static electricity should be taken to avoid
breakdown of devices or degradation of characteristics.
?/DIV>
Design guide
1) Prevention of detection error
To prevent photointerrupter from faulty operation caused by external light, do not set the detecting face to
the external light.
2) In order to stabilize power supply line, connect a by-pass capacitor of more than 0.01糉 between V
CC
and
GND near the device.
3) Position of opaque board
Opaque board shall be installed at place 4mm or more from the top of elements.
(Example)
4mm or more
This product is not designed against irradiation and incorporates non-coherent IRED.
?/DIV>
Degradation
In general, the emission of the IRED used in photocouplers will degrade over time.
In the case of long term operation, please take the general IRED degradation (50% degradation over 5
years) into the design consideration.
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
GP1A53HRJ00F
PHOTOINTER OPIC SLOT 5.0MM PCB
GP1A57HRJ00F
PHOTOINTER OPIC SLOT 10MM PCB
GP1A58HRJ00F
PHOTOINTER OPIC SLOT 5.0MM PCB
GP1A75E
PHOTOINTER OPIC SLOT 5.0MM W/CON
GP1L52VJ000F
SENSOR OPTO SLOT 3MM DARL THRU
GP1S092HCPIF
SENSOR OPTO SLOT 2MM TRANS SMD
GP1S093HCZ0F
SENSOR OPTO SLOT 2MM TRANS THRU
GP1S094HCZ0F
SENSOR OPTO SLOT 3MM TRANS THRU
相关代理商/技术参数
GP1A53HR
功能描述:PHOTOINTER OPIC SLOT 5.0MM PCB RoHS:否 类别:传感器，转换器 >> 光学 - 光断续器 - 槽型 - 逻辑输出 系列:OPIC™ 产品变化通告:Product Discontinuation 03/Dec/2009 标准包装:50 系列:OPTOLOGIC® 检测距离:0.197"（5mm） 检测方法:可传导的 输出配置:NPN - 开路集电极，缓冲器 安装类型:通孔 电流 - 电源:5mA 电源电压:4.5 V ~ 16 V 响应时间:70ns 封装/外壳:PCB 安装
GP1A53HRJ00F
功能描述:光学开关（透射型，光电IC输出） Case Type Photntrptr 3.0mm 0.5mm Screw RoHS:否 制造商:Optek 输出设备:Totem Pole, Buffer 槽宽:3.18 mm 光圈宽度:1.27 mm 正向电流:40 mA 最大工作温度:+ 70 C 最小工作温度:- 40 C 封装:
GP1A53HR-J00F
制造商:Sharp Microelectronics Corporation 功能描述:
GP1A57
制造商:SHARP 制造商全称:Sharp Electrionic Components 功能描述:Wide Gap Type OPIC Photointerrupter
GP1A57HR
功能描述:PHOTOINTER OPIC SLOT 10MM PCB RoHS:否 类别:传感器，转换器 >> 光学 - 光断续器 - 槽型 - 逻辑输出 系列:OPIC™ 产品变化通告:Product Discontinuation 03/Dec/2009 标准包装:50 系列:OPTOLOGIC® 检测距离:0.197"（5mm） 检测方法:可传导的 输出配置:NPN - 开路集电极，缓冲器 安装类型:通孔 电流 - 电源:5mA 电源电压:4.5 V ~ 16 V 响应时间:70ns 封装/外壳:PCB 安装
GP1A57HRJ00F
功能描述:光学开关（透射型，光电IC输出） OPIC Photointerruptr Schmdt Gap 10.0mm RoHS:否 制造商:Optek 输出设备:Totem Pole, Buffer 槽宽:3.18 mm 光圈宽度:1.27 mm 正向电流:40 mA 最大工作温度:+ 70 C 最小工作温度:- 40 C 封装:
GP1A58HR
功能描述:PHOTOINTER OPIC SLOT 5.0MM PCB RoHS:否 类别:传感器，转换器 >> 光学 - 光断续器 - 槽型 - 逻辑输出 系列:OPIC™ 产品变化通告:Product Discontinuation 03/Dec/2009 标准包装:50 系列:OPTOLOGIC® 检测距离:0.197"（5mm） 检测方法:可传导的 输出配置:NPN - 开路集电极，缓冲器 安装类型:通孔 电流 - 电源:5mA 电源电压:4.5 V ~ 16 V 响应时间:70ns 封装/外壳:PCB 安装
GP1A58HRJ00F
功能描述:光学开关（透射型，光电IC输出） OPIC Photointerruptr Cnctr Gap/Silt 5.0mm RoHS:否 制造商:Optek 输出设备:Totem Pole, Buffer 槽宽:3.18 mm 光圈宽度:1.27 mm 正向电流:40 mA 最大工作温度:+ 70 C 最小工作温度:- 40 C 封装: